- ページ 8

バスタブ Kohler K-1109のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-1109 32 ページ。 Bath whirlpool
Kohler K-1109 にも：ホームオーナーズマニュアル (36 ページ), インストレーション・マニュアル (36 ページ)

6. Make Electrical Connections

NOTE: The whirlpool model number is printed on a label near the whirlpool pump. This label also identifies the

electrical rating of the whirlpool.

WARNING: Risk of electrical shock. To reduce the risk of electrical shock, connect the pump to a properly

grounded, grounding-type receptacle protected by a Ground-Fault Circuit-Interrupter (GFCI). Do not remove

the plug's grounding pin. Do not use a grounding adapter.

- Your Kohler whirlpool bath is equipped with a cord and plug. All wiring of the pump and control has been

completed at the factory. A licensed electrician must install a GFCI-protected, 120 V, 15 A, grounded outlet. No

other load should be on this circuit. Locate the outlet behind the whirlpool, and within 24" (61cm) of the pump.

- Plug the pump into this outlet.

NOTE: Make sure the air actuator tubing is securely attached to the pump and actuator switch, and is not kinked

or damaged.

In-line Heater Wiring

- "H" Models: The in-line heater is equipped with a cord and plug. All wiring of the heater has been completed at

the factory. A licensed electrician must install a GFCI-protected, 120 V, 15 A, grounded outlet. No other load

should be on this circuit. Locate the outlet behind the whirlpool, and within 24" (61cm) of the heater.

- Plug the in-line heater into this outlet.

- Check all electrical connections, and make sure the electrical power to the whirlpool is turned on.

- Make sure all union connections to the pump are securely hand tightened.

- Verify that the pump banding straps have been cut.

- Fill the whirlpool to a level at least 2" (5cm) above the top of the highest jet.

- Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.

- For additional information on whirlpool operation, see Confirm Proper Operation on Page 10.

1010997-2-

Install a GFCI-protected 120 V, 15A

grounded outlet

Plug the pump into this outlet

Bond in accordance

with applicable codes

Install a second

GFCI-protected outlet for

"H" models for the in-line

heater

Kohler Co.