- ページ 6

バスタブ Kohler K-1126のPDF ホームオーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-1126 32 ページ。 Bath whirlpool
Kohler K-1126 にも：インストレーション・マニュアル (48 ページ), インストレーション・マニュアル (44 ページ), インストレーション・マニュアル (44 ページ), ラフイン・マニュアル (4 ページ), インストレーション・マニュアル (48 ページ)

ページを印刷する

One-Year Warranty - For Mexico (cont.)

4. The time of repair will not exceed six (6) weeks commencing on the date the product is received.

5. It is recommended that the consumer save the invoice or receipt as additional protection, as it may

substitute the warranty in the case that there is a discrepancy in the validity of the warranty.

EXCEPTIONS AND RESTRICTIONS

The Warranty will not be valid in the following cases:

1. When the product is not operated in accordance with the instructions concerning use and operation set

forth in the owner's manual or installation instructions, and when the recommendations and warnings

included are not observed.

2. When the product has been modiﬁed or dismantled partially or totally; or has been used in a negligent

fashion and as a consequence has suffered damages attributable to the consumer, individual, or hardware not

authorized by Kohler Co.

3. This warranty does not cover the damages as a result of disaster such as ﬁre or acts of God, including

ﬂooding, earthquake, or electric storms, etc. To obtain a list of distributors in your area where you can

exercise your rights under this warranty, please call 001-877-680-1310.

KOHLER CO., KOHLER, WI 53044 U.S.A.

IMPORTER:

INTERNACIONAL DE CERÁMICA, S.A.B. DE C.V.

AV. CARLOS PACHECO NO. 7200

CHIHUAHUA, CHIH., MEXICO C.P. 31060

TEL: 52 (14) 29-11-11

Troubleshooting Procedures

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualiﬁed

electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Symptoms

Whirlpool will not

start/stop.

1010564-5-J

Probable Causes

A. No power to pump.

B. Remove the access panel and

press the air switch, if you do not

hear a "click," the air switch

tubing is loose or disconnected.

C. Air switch tubing is pinched or

kinked.

D. Push button assembly is damaged. D. Replace the push button

E. Pump has power and a "click" is

heard when the air switch is

pressed. Pump is defective.

Recommended Action

A. Verify pump is plugged in and

the GFCI/ELCB is not tripped.

Verify the outlet has power using

a multi-meter or by connecting a

110V item that you know is

working (lamp, radio, etc.) into

the outlet. Repair as needed.

B. Check if the air switch tubing is

connected at both the

receiver/pump end and the air

switch. Reconnect if needed.

C. Adjust tubing to clear the

pinched/kinked area. If the

pinch/kink cannot be ﬁxed, or

no noticeable pinch/kink is

apparent, puncture the tubing

with a tack and try the system

again.

assembly.

E. Replace the pump.

Kohler Co.