- ページ 14

バスタブ Kohler K-1131のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-1131 48 ページ。 Bath whirlpool
Kohler K-1131 にも：ホームオーナーズマニュアル (32 ページ), インストレーション・マニュアル (48 ページ), インストレーション・マニュアル (44 ページ), インストレーション・マニュアル (44 ページ)

ページを印刷する

Insert the tool hook as shown and pull the jet out of the

housing. The jet should be facing up when this is done.

13. Troubleshooting Procedure

Remove the Factory Installed Jets

NOTE: A special tool is provided with the replacement jets that will allow you to remove the jets from the

whirlpool. This tool is also supplied with each trim kit.

Position the jet ball nozzle so it is pointing upward.

NOTE: The nozzle must remain pointed up or the tool will slip off.

Insert the removal tool, hooked end up, into the opening of the jet and hook the inside top of the nozzle.

Grasp the tool ﬁrmly and place your thumb against the whirlpool wall. Pull steadily on the tool until the

jet assembly pulls free of the hole. Be careful not to lose the O-ring.

Reinstall the Jets

NOTE: The jet O-ring must be correctly positioned, must be lubricated, and must be in good condition to

permit easy rotation and proper operation of the jet.

Install the O-ring onto the ﬁrst shoulder of the jet. Lubricate the O-ring with silicone lubricant to prevent

noisy operation of the jet.

Carefully insert the jet into the housing, and lightly push and rotate the jet until it snaps into position. Do

not force the jet.

NOTE: When installed correctly, the jet should turn smoothly both clockwise and counterclockwise.

Troubleshooting Guide

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualiﬁed

electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale

distributor.

Symptoms

1. Whirlpool does not start or

stop.

1010564-2-B

Probable Causes

A. No power to motor.

B. Air actuator does not work.

C. Air actuator tubing is

disconnected, loose, kinked,

plugged, or damages.

Re-install the Jets

Slide the O-ring

onto the first

shoulder of the jet

Insert the jet into the housing, and lightly

push and rotate until it snaps in position

Recommended Action

A. Set/reset GFCI breaker;

check wiring.

B. Replace air actuator.

C. Connect, straighten, clean, or

replace air actuator tubing.

Inspect and

lubricate the

O-ring

Kohler Co.