- ページ 13

バスタブ Kohler K-1144のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-1144 48 ページ。 Bath whirlpool
Kohler K-1144 にも：ホームオーナーズマニュアル (32 ページ), インストレーション・マニュアル (48 ページ), インストレーション・マニュアル (44 ページ), インストレーション・マニュアル (44 ページ)

Turn the jet trim

ring clockwise to

decrease the flow

Turn the jet trim ring

counterclockwise to

increase the flow

12. Conﬁrm Proper Operation

NOTE: Please read these steps carefully before you operate your whirlpool.

Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully counterclockwise.

Fill the whirlpool to a water level at least 2" (5.1cm) above the top of the highest jet.

NOTE: The water temperature in the whirlpool should not exceed 104° F (40° C).

Press the air actuator to turn on the whirlpool jets.

Adjust each jet for optimum air/water mixture. Turn the trim ring clockwise to reduce the air ﬂow, and

counterclockwise to increase the air ﬂow.

If equipped with an in-line heater, the heater will engage automatically when the pump is turned on and

will disengage when the pump is turned off. The heater will not turn on if the water temperature exceeds

104° F (40° C).

Press the air actuator a second time to turn off the whirlpool.

NOTE: The optional K-1639 Timer Kit automatically stops the whirlpool after approximately 20 minutes of

operation.

Kohler Co.

Fill with water 2" (5cm)

above the highest jet

Position the jet

nozzles to direct

the water flow as

desired

Press the air actuator to turn on and

off the whirlpool

1010564-2-B