- ページ 5

トイレ Kohler WELLWORTH LITE K-3421のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler WELLWORTH LITE K-3421 8 ページ。 Vitreous china reverse trap toilets

ページを印刷する

TO CONNECT WATER SUPPLY

NOTICE: Read carefully before performing this step.

For supply installation, refer to instructions packed with

shut-off valve. Carefully bend tubing to fit.

Cut tubing end 1/4" longer than distance between shut-off

valve and supply shank. Remove any burrs from inside of

tube.

Slip coupling nut, compression nut, and ferrule onto

tubing. Insert tubing into shut-off valve and supply shank,

positioning seal washer (supplied) or compression

washer (not supplied) as shown. Hand-tighten coupling

nut and then tighten compression nut.

WARNING: Risk of external leakage. The fill

valve nut has been factory-tightened to design

specifications. If re-tightening is required, wrench

tighten one turn past finger tight.

Turn shut-off valve on and check for leaks. If connections

are squarely assembled, a slight retightening of the nuts

will stop any leaks.

If toilet is leaking in between the tank and bowl, carefully

retighten the three tank bolts evenly. Check all bowl and

tank connections for leaks for several days.

Hold float under water for a few seconds to fill ballast.

Adjust float by sliding it up or down on float rod until water

level is at the marked water line on the flush valve over-

flow.

Check all connections for leaks for several days.

Kohler Co., Kohler, WI

Supply Shank

Seal Washer

Tubing

Coupling Nut

Compression Nut

Ferrule

Shut-Off Valve

Fig. #8

Float

Fig. #10

Supply Shank

Compression Washer

Tubing

Coupling Nut

Compression Nut

Ferrule

Shut-Off Valve

Fig. #9

Float Rod

112375-2-

(B)