- ページ 12

エンジン Kohler Aegis LH685のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Kohler Aegis LH685 21 ページ。 Horizontal-shaft
Kohler Aegis LH685 にも：オーナーズマニュアル (8 ページ)

ページを印刷する

1. Parts Ordering

2. Reinstall and tighten the radiator cap.

3. Start and run the engine for five minutes, or until

it reaches operating temperature. Stop the engine

and allow it to cool.

4. Drain the cooling system (Refer to Draining

Cooling Systems).

5. Fill the cooling system (see Filling Cooling

System).

Filling Cooling System

1. Check the condition of cooling system hoses,

clamps, and associated components. Replace as

required.

2. Mix equal parts of ethylene glycol anti-freeze and

distilled or deionized water (see Coolant

Recommendations on page 5). For extremely cold

temperature applications or protection outside

the limits listed in the Coolant Recommendations

Section, refer to the anti-freeze manufacturers

instructions on the container, but do not exceed

70% anti-freeze.

3. Fill the radiator with the coolant mixture. Allow

coolant to drain into the lower areas. Fill the

overflow reservoir to a level between the ''FULL''

and ''ADD'' marks. See Figure 9. Reinstall the

radiator and reservoir caps.

4. Start and run the engine for five minutes. Stop

the engine and allow to cool.

5. Recheck the coolant level in the reservoir. Coolant

level should be between the ''FULL'' and ''ADD''

marks. Add coolant to reservoir if required. See

Figure 9.

Air Cleaner Element and Inner Element

Service

This engine is equipped with a heavy-duty high

density paper air cleaner element surrounding a

canister style inner element. Cleaning is not

recommended, each element should be replaced when

dirty. See Figure 14.

The air cleaner system should be inspected daily or

before starting the engine, for a buildup of dirt and

debris, or for any damaged or loose components. Keep

the system clean and properly secured. Replace any

damaged air cleaner comments. Do not operate the

engine without the complete air cleaner system

installed and properly secured.

Figure 14. Air Cleaner Element and Inner Element.

NOTE: Operating the engine with loose, damaged, or

missing air intake components can allow

unfiltered air into the engine, causing

premature wear and failure.

To Service

Every 250 hours of operation (more often under

extremely dusty or dirty conditions), replace the paper

element and check the inner element. Follow these

steps.

1. Unhook the two retaining clips and remove the

end cap from the air cleaner housing. See Figure 15.

Figure 15. Removing End Cap.

2. Pull the air cleaner element out of the housing.

See Figure 16.

Figure 16. Removing Air Cleaner Element.

Inner

Element

Air Cleaner

Element