- ページ 8
エンジン Kohler Command 6 HPのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Kohler Command 6 HP 17 ページ。 Horizontal crankshaft
Kohler Command 6 HP にも： オーナーズマニュアル (16 ページ), オーナーズマニュアル (16 ページ), オーナーズマニュアル (16 ページ)
ページを印刷する
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at
the customers expense, may be performed by any non-road engine repair establishment or individual.
Warranty repairs must be performed by an authorized Kohler service outlet.
WARNING: Accidental Starts!
Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or
equipment, disable the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery
cable from battery.
Maintenance Schedule
These required maintenance procedures should be performed at the frequency stated in the table. They should also
be included as part of any seasonal tune-up.
Frequency
Daily or Before
Starting Engine
Every 25 Hours
Every 100 Hours
Every 200 Hours
Annually or
Every 500 Hours
¹Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.
²Have a Kohler Engine Service Dealer perform this service.
Check Oil Level
The importance of checking and maintaining the proper
oil level in the crankcase cannot be overemphasized.
Check oil BEFORE EACH USE as follows:
1. Make sure the engine is stopped, level, and is cool
so the oil has had time to drain into the sump.
.
2. To keep dirt, debris, etc., out of the engine, clean
the area around the oil fill/check plug before
removing it.
3. Unthread and remove the oil fill/check plug.
4. The level should be up to but not over, the point of
overflowing the filler neck.
8
Maintenance Instructions
Maintenance Required
• Fill fuel tank.
• Check oil level.
• Check air cleaner for dirty¹, loose, or damaged parts.
• Check air intake and cooling areas, clean as necessary¹.
• Service precleaner element¹.
• Replace air cleaner element¹.
• Change oil.
• Remove cooling shrouds and clean cooling areas¹.
• Check spark plug condition and gap.
• Have bendix starter drive serviced
• Have valve to rocker arm clearance checked².
• Have Oil Sentry™ float switch checked
2
.
2
.
Filler
Neck
Oil Drain
Plug
Oil Fill/Check Plug
Figure 7. Location of Oil Drain and Check Plugs.
NOTE: Just because you can see oil in the crankcase
doesn't mean the level is in the safe range.
Bring the level up to the point of overflowing the
filler neck.