- ページ 9

エンジン Kohler SNOWPRO WH208のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Kohler SNOWPRO WH208 12 ページ。 Horizontal crankshaft
Kohler SNOWPRO WH208 にも：オーナーズマニュアル (17 ページ)

ページを印刷する

1. Change Oil

Figure 26. Oil Fill Cap/Dipstick and Oil Fill Tube.

3. Unscrew and remove the oil fill cap/dipstick;

wipe off oil. Reinsert the dipstick into the oil fill

tube and screw in.

4. Unscrew and remove the oil fill cap/dipstick and

check that oil level is correct. The correct oil level

is between the F and L marks on the dipstick. See

Figure 27.

Oil Fill

Cap

Dipstick

Figure 27. Correct Oil Level.

5. If the level is low, add oil of the proper type (refer

to Oil Recommendations) and to the correct

level. Always check the level before adding more

oil.

Oil Fill Cap/

Dipstick

Oil Fill

Tube

Operating

Range

NOTE: To prevent extensive engine wear or damage,

always maintain the proper oil level in the

crankcase. Never operate the engine with the

oil level above or below the correct operating

range.

6. Reinstall the oil fill cap/dipstick and tighten

securely. See Figure 26.

Change Oil

For a new engine, change oil after the first 5 hours of

operation. Thereafter, change oil yearly.

For an overhauled engine, use Kohler 5W-30 service

class, SJ or higher oil for the first 5 hours of operation.

Change the oil after this initial run-in period. Refill

with service class SJ or higher oil as specified in the

Oil Viscosity Grades Table (Figure 2).

Change the oil while the engine is still warm. The

oil will flow freely and carry away more impurities.

Make sure the engine is level when filling, checking,

or changing the oil.

Change the oil as follows:

1. To keep snow, ice, etc., out of the engine, clean

the area around the oil fill cap/dipstick before

removing it. See Figure 26.

2. Remove the oil drain plug and the oil fill cap/

dipstick. Allow ample time for complete

drainage. See Figures 26 and 28.

Oil Drain Plug

Figure 28. Oil Drain Plug Location.

3. Reinstall the oil drain plug and tighten to

9-13.5 N·m (80-120 in. lb.). See Figure 28.

4. Fill the crankcase, with new oil of the proper

type. Refer to Oil Recommendations. Always

check the level before adding more oil.