- ページ 31

ポータブル発電機 Kohler 10ERGのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Kohler 10ERG 48 ページ。 Commercial mobile generator set

ページを印刷する

3.10 Battery

Consult

the

battery

regarding battery care and maintenance.

WARNING

Sulfuric acid in batteries.

Can cause severe injury or death.

Wear

protective

clothing.

Battery acid may cause

blindness and burn skin.

Battery electrolyte is a diluted sulfuric acid. Battery acid

can cause severe injury or death. Battery acid can cause

blindness and burn skin. Always wear splashproof safety

goggles, rubber gloves, and boots when servicing the battery.

Do not open a sealed battery or mutilate the battery case. If

battery acid splashes in the eyes or on the skin, immediately

flush the affected area for 15 minutes with large quantities of

clean water. Seek immediate medical aid in the case of eye

contact. Never add acid to a battery after placing the battery in

service, as this may result in hazardous spattering of battery

acid.

Battery gases. Explosion can cause severe injury or

death. Battery gases can cause an explosion. Do not smoke

or permit flames or sparks to occur near a battery at any time,

particularly when it is charging. Do not dispose of a battery in a

fire.

To prevent burns and sparks that could cause an

explosion, avoid touching the battery terminals with tools or

other metal objects. Remove all jewelry before servicing the

equipment. Discharge static electricity from your body before

touching batteries by first touching a grounded metal surface

away from the battery. To avoid sparks, do not disturb the

battery charger connections while the battery is charging.

Always turn the battery charger off before disconnecting the

battery connections. Ventilate the compartments containing

batteries to prevent accumulation of explosive gases.

TP-6334

9/04

manufacturer's

instructions

goggles

and

3.11 Belt Check

Check the belt tension at the intervals specified in the

service schedule. If the tension is not within

specification, adjust as necessary using the following

procedure.

Adjust the tension of the alternator/fan belt so that the

belt can be depressed about 12.7 mm (0.5 in.) when

applying finger pressure. Use the following procedure

to adjust the belt.

1. Battery charging alternator pulley

2. Adjusting screw

3. Check the alternator belt tension here

4. Alternator pivot screw

Figure 3-11 Belt Tension

Belt Tensioning Procedure

1. Disconnect the battery, negative lead first.

2. Loosen the pivot and adjusting screws.

3. While prying the battery charging alternator

outward, tighten the adjusting screw.

4. Tighten the pivot screw.

5. Recheck and adjust as necessary.

6. Reconnect the battery, negative lead last.

Note: Also check the fan belt for cracks or tears

and replace the belt if necessary.

Scheduled Maintenance 19