- ページ 24

ポータブル発電機 Kohler 12RESM1のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler 12RESM1 36 ページ。 Residential/commercial generator sets
Kohler 12RESM1 にも：インストレーション・マニュアル (40 ページ), マニュアル (36 ページ), 操作マニュアル (48 ページ), オペレーション (48 ページ)

ページを印刷する

2.8 Carburetor Heater

Generator sets are available with or without the

carburetor

heater.

recommended for improved cold starting in locations

where the ambient temperature drops below 0_C

(32 _F). The carburetor heater prevents condensation

and carburetor icing. The heater turns on when the

temperature at the thermostat falls below approximately

4_C (40_F) and turns off when the temperature rises

above approximately 16_C (60_F).

The heater requires a continuous source of 120 VAC

power. A 120 VAC receptacle is located inside the

generator set housing air intake area. See Figure 1-1.

The wiring kit includes leads for the receptacle. Connect

the receptacle leads to a circuit breaker in the essential

load panel in the ATS enclosure to ensure that the

receptacle is always powered. See Section 2.6.1 for

connection information.

1. Thermostat

2. Heater

Figure 2-19 Carburetor Heater with Thermostat

Section 2 Installation

The

carburetor

heater

The carburetor heater is installed between the

carburetor and the air cleaner. See Figure 1-1 for the

location.

The heater thermostat is installed in the cord.

Figure 2-19 shows the location of the thermostat on the

power cord. The thermostat is located in the air intake

area.

Note: Do not place the heater thermostat inside the

generator set engine compartment.

thermostat must be exposed to the ambient air.

The thermostat will shut off power to the heater

when

the

approximately 16_C (60_F).

ambient

temperature

TP-6397 4/07

The

reaches

GM40129