- ページ 9

ポータブル発電機 Kohler 12TRESのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Kohler 12TRES 36 ページ。 Advanced digital control adc-res

Kohler 12TRES 操作マニュアル
This manual provides operation and maintenance
instructions for model 17RES generator sets equipped
with the Kohlerr ADC-RES Advanced Digital Control.
This generator set is approved for use in stationary
applications in locations served by a reliable utility
power source. Have the generator set installed by an
authorized distributor/dealer or service technician.
Refer to TP-6514, Installation Manual, for installation
instructions.
Information in this publication represents data available
at the time of print. The manufacturer may provide this
manual for models not listed on the front cover. Kohler
Co. reserves the right to change this publication and the
products represented without notice and without any
obligation or liability whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section at the
beginning of this manual. Keep this manual with the
equipment for future reference.
The equipment service requirements are very important
to safe and efficient operation. Inspect the parts often
and perform required service at the prescribed intervals.
Obtain service from an authorized service distributor/
dealer to keep equipment in top condition.
Nameplate
The following illustration shows a typical generator set
nameplate. Copy the model, serial, and specification
numbers from the nameplate into the spaces provided in
the product information section on the inside front cover
of this manual. See Section 1.5, Service Views, for the
nameplate location.
TP-6515 10/07

Emission Compliance

An engine or generator set with the following
identification label is certified to meet Small Off-Road
Engine emission standards for EPA/CARB.
This engine/generator is certified to operate using
natural gas or propane fuel.
The 17RES generator set engine is certified to meet
emission regulations for U.S. EPA phase 2 small
off-road engines and CA 2006 and later LSI engines
(large spark-ignited engines at or below 1 liter).
Figure 1 Engine Identification Label
The Emission Compliance Period referred to on the
Engine Identification label indicates the number of
operating hours for which the engine has been shown to
meet EPA emission requirements.
compliance period (in hours), associated with the
Category A descriptor found on the certification label, is
1000 hours.
Refer to the certification label for engine displacement.
The exhaust emission control system for the CH980
engine is EM.

Introduction

The engine
Introduction
9