- ページ 29
ポータブル発電機 Kohler 14RESのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler 14RES 48 ページ。 Residential and light commercial generator sets
Kohler 14RES にも： トラブルシューティングマニュアル (8 ページ)
ページを印刷する
1.11.2 Carburetor Heater
An optional carburetor heater is recommended for
improved cold starting in locations where the ambient
temperature drops below 0_C (32_F). The carburetor
heater prevents condensation and carburetor icing. The
heater turns on when the temperature at the thermostat
falls below approximately 4_C (40_F) and turns off when
the temperature rises above approximately 16_C
(60_F).
The carburetor heaters are shown in
Figure 1-26.
To install the carburetor heater, follow the instructions
provided with the kit. Figure 1-27 shows the installed
carburetor heater kit installed for a 14 kW generator set.
Figure 1-28 shows the location for the carburetor heater
kit on a 20 kW generator set.
The heater thermostat is installed in the cord.
Figure 1-26 shows the location of the thermostat on the
power cord. The heater power cord and thermostat are
located in the generator set housing air intake area/
battery compartment.
Note: Do not place the heater thermostat inside the
generator set engine compartment.
thermostat must be exposed to the ambient air.
The heater requires a continuous source of power. Plug
the carburetor heater into one of the 120 VAC
receptacles provided.
1
2
14RES/RESL Carburetor Heater
1
2
20RES/RESL Carburetor Heater
1. Power plug
2. Thermostat
3. Heater
Figure 1-26 Carburetor Heaters
TP-6733 8/11
1. Carburetor heater (air cleaner removed to show heater)
2. Carburetor heater power cord
The
Figure 1-27 14RES/RESL Carburetor Heater
3
GM19463
1. Carburetor heater location
3
Figure 1-28 20RES/RESL Carburetor Heater
GM57968
2
1
Location on Engine (bulkhead removed
to show heater location)
Section 1 Installation
tp6195
1
tp6514
29