- ページ 23

ポータブル発電機 Kohler 14RESLのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler 14RESL 48 ページ。 Residential and light commercial generator sets
Kohler 14RESL にも：トラブルシューティングマニュアル (8 ページ)

ページを印刷する

1.8.3

Field-Connection Terminal Block

The generator set is equipped with a field-connection

terminal block located in the air inlet area near the

junction box. Leads have been factory-installed from

the junction box to the terminal block for easy field

wiring.

See the dimension drawing in Section 1.5 for the

terminal block location. See Figure 1-19 or Figure 1-20

for terminal block details. Refer to the terminal block

decal for connections and cable sizes. Also see

Section 2, Wiring Diagrams.

Note: The connections on the revised terminal block

are arranged in a different order than the original.

Be sure to follow the connections shown on the

decal on the generator set.

Route AC leads through flexible conduit. Ensure that

the leads and conduit do not interfere with the operation

of the generator set or obstruct the service areas. Route

low-voltage communication leads through separate

conduit.

1. Field-connection terminal block

2. Decal

Figure 1-19 Original Field-Connection Terminal Block

TP-6733 8/11

Procedure

GM66565

Figure 1-20 Revised Terminal Block

1. Drill holes for the conduit fittings.

Figure 1-17 and Appendix B for the recommended

electrical inlet locations. Feed the cables through

the openings.

2. Connect the leads from the transfer switch

emergency source lugs to the L1 and L2

connections on the generator set terminal block.

3. Connect the neutral (L0) and ground (GRD) leads

from the ATS and the main panel to the

corresponding connection points on the terminal

block. See Section 1.8.4, Grounding.

1. Terminal block

2. Decal

See the

GM80177

Section 1 Installation