- ページ 6

ポータブル発電機 Kohler 20RESCのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Kohler 20RESC 37 ページ。 Residential/commercial generator sets
Kohler 20RESC にも：インストレーション・インストラクション (2 ページ), オペレーション (20 ページ)

ページを印刷する

5. Install the adaptor harnesses for voltage sensing

connection:

a. Disconnect the generator set harness at P2 on

the back of the RDC2 controller. See Figure 6.

b. Connect the adaptor harness to P2 on the

RDC2 controller. See Figure 6 and Figure 8.

c. Connect the other end of the adaptor harness

to the generator set harness.

d. Repeat for the second generator set.

6. The adaptor harness connected in step 5 contains

a voltage sensing lead (V9). Connect one 14-20

AWG lead to this lead and route it with the AC

output leads from the generator to the APM

location. Repeat for the second generator set.

Note: Do not operate the generators in parallel without

the adaptor harness in place.

harness contains protective devices that prevent

controller damage when connecting to a large

inductive load (such as another generator).

Note: Electrical connections to the APM will be made

later.

Figure 8 Adaptor/Protection Harness GM86610 (provided)

1.2 Install the automatic paralleling

module (APM).

7. To remove the enclosure's front panel, support the

panel while removing the screws. Pull the bottom

of the panel out and down until the top clears the

enclosure. Remove the inner panel to access the

APM components.

8. See the dimension drawings in Section 8 for

recommended cable entrance areas. Cover the

components inside the enclosure. Then punch or

drill cable entry openings in the APM enclosure.

9. Use a vacuum cleaner to remove debris from the

enclosure.

Note: Do not use compressed air to clean the

The adaptor

10. Mount the enclosure to a wall or other rigid vertical

supporting structure using the mounting holes

provided in the enclosure.

mounting hole spacing. Use shims to plumb the

enclosure.

Note: The enclosure mounting holes are equipped

VOLTAGE SENSING LEAD (TO APM)

inside of the enclosure.

compressed air can cause debris to lodge

inside the components and damage the

equipment.

with gaskets to seal out moisture.

washers with the mounting screws to

prevent damage to the gaskets.

Cleaning with

See Figure 32 for

Use

GM86610

TT-1596

8/22