- ページ 15

ポータブル発電機 Kohler 6VSGのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler 6VSG 44 ページ。 Dc generator sets

ページを印刷する

8. Clean the plug with a dry cloth or brush, apply

fresh pipe sealant, and install the plug into the LP

port.

9. Clean the hose fitting with a dry cloth or brush,

apply fresh pipe sealant to the threads, and install

the fitting into the NG port.

Note: Do not adjust the fuel metering valves.

10. Slide the hose onto the hose fitting and secure it

with the clamp.

11. Connect and turn on the new fuel supply.

Figure 1-7

1. Fuel regulator

Figure 1-7

Fuel System

12. Reconnect the generator set engine starting

battery leads, negative (–) lead last.

13. Reconnect the utility power to the generator set.

14. Start the generator set by pressing the RUN

button on the generator set controller.

15. Check for leaks using a gas leak detector.

16. Run the generator set and check the operation.

17. Press the OFF button to shut down the generator

set.

Conversion from Natural Gas to LPG

To convert from natural gas to LPG, follow the fuel

conversion procedure above, moving the hose fitting

to the LPG port and plugging the NG port.

The National Electrical Code

TP-6842 7/15

KPS_035

is a registered trademark of the National Fire Protection Association, Inc.

1.8 Electrical Connections

Hazardous voltage.

Will cause severe injury or death.

This equipment must be installed

and serviced by qualified electrical

personnel.

Grounding electrical equipment. Hazardous voltage can

cause severe injury or death. Electrocution is possible

whenever electricity is present. Ensure you comply with all

applicable codes and standards.

generator set, transfer switch, and related equipment and

electrical circuits. Turn off the main circuit breakers of all

power sources before servicing the equipment.

contact electrical leads or appliances when standing in water

or on wet ground because these conditions increase the risk

of electrocution.

Have an authorized distributor/dealer or a licensed

electrician make the following electrical connections.

The electrical installation must comply with the

National Electrical Code

designation and all applicable local codes. Canadian

installations must comply with the Canadian Electrical

Code (CEC) and applicable local codes.

1.8.1

Grounding

The 6VSG has an isolated output, which should be

referenced to ground. This can be accomplished by

connecting either the positive or the negative DC

output lead to ground.

recommended in this application.

DANGER

Electrically ground the

(NEC) class 1 wire

A floating voltage is not

Section 1 Installation

Never