- ページ 3

ポータブル発電機 Kohler GM62345のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler GM62345 8 ページ。 6--60 kw residential and light commercial generator sets

ページを印刷する

1. Spark Plugs

Maintenance Procedures

Oil and Oil Filter

When possible, drain the oil while it is warm.

Before working on the generator set or connected

equipment, disable the generator set as follows:

Press the OFF button on the generator set controller.

Disconnect the power to the battery charger.

Remove the battery cables, negative (--) lead first.

2. For most models [except 8/10/12RESV(L)], a

drain plug is located on the service side of the

generator set, opposite the starter. If you have

difficulty locating the drain plug, see the service

view in your generator set operation manual. For

8/10/12RESV(L), proceed to step 3.

a. Remove one oil drain plug and the oil fill cap/

dipstick. Aim the drain tube into catch basin

and open the valve near the oil sump. Allow

ample time for complete drainage.

b. Close the valve and place the tube back in the

clip on the bulkhead wall.

c. Remove the old filter and wipe off the

adapter/base on the engine.

d. Proceed to step 4.

3. For 8/10/12RESV(L) models, use the following

procedure to avoid spilling oil into the alternator.

a. To prevent oil from spilling into the alternator,

cover the alternator with rags around the areas

near the oil drain valve and oil filter.

b. Place a drain tube (3/8 in. inside diameter) onto

the oil drain valve and place the end of the tube

into a drain pan. The tube will reduce the

potential for spilled oil.

c. Open the oil drain valve on the engine.

d. Remove the dipstick and oil fill cap. Allow time

for the engine oil to drain completely.

TT-1445

7/16

e. Close the oil drain valve and remove the oil

drain tube.

f. Tilt the filter upward to prevent spilling as you

remove the oil filter. Remove the old filter and

wipe off the adapter/base on the engine.

4. Place a new replacement filter in a shallow pan with

the open end up. Pour new oil (provided) through

the threaded center hole. Stop pouring when the oil

reaches the bottom of threads. Allow a minute or

two for the oil to be absorbed by the filter material.

5. Apply a thin film of clean oil to the rubber gasket on

the new oil filter.

6. Install new oil filter. Hand tighten filter clockwise

until the rubber gasket contacts the adapter, then

tighten the filter an additional 3/4--1 turn.

7. Fill the crankcase with the new oil to the F or FULL

mark on the dipstick. Use a funnel to prevent

spilling. Always check the level with the dipstick

before adding more oil. Never operate the engine

with the oil level below the L or ADD mark, or above

the F or FULL mark. See Figure 2.

8. For 8/10/12RESV(L) models, remove the rags

that were used to cover the alternator.

Full Mark

Operating

Range

Figure 2 Oil Level/Dipstick Detail

9. Reinstall the oil fill cap/dipstick and tighten

securely.

10. Reconnect the battery cable, negative (--) lead last.

11. Test run the engine, check for leaks, and recheck

the oil level.

TT-1484