- ページ 3

室内装飾品 Kohler K-2607のPDF インストレーション＆ケア・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-2607 32 ページ。 Bridge cabinet

Clip

Cross Rail

1. Install Legs (Single Vanity Installation)

IMPORTANT! Legs are not required for installation between two

vanities.

NOTE: To protect the ﬁnished surface of the cabinet, perform

assembly tasks on a ﬂat, padded work surface.

Place the cabinet upright on a ﬂat, padded surface.

Remove the drawer to access the holes for leg attachment. Refer

to the "Remove/Reinstall the Drawer" section of this guide.

Determine whether the legs will be installed on the left or right.

The opposite side will be supported when installed to the K-2604

vanity.

Lay the cabinet on its side and position each leg so the clips face

toward each other (as shown).

Secure each leg post using two #8 x 2" panhead screws, lock

washers, and ﬂat washers.

Position the cross rail above the clips between the front and back

legs (as shown).

Evenly press down on the cross rail until the clips are fully

engaged. You may need to apply slight pressure on each end

until it clicks in place.

Kohler Co.

Rear Leg

Screw

Clip

Front

Leg

1207227-2-A