- ページ 7

室内装飾品 Kohler K-3082のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-3082 36 ページ。 Mirrored cabinet
Kohler K-3082 にも：インストレーション・マニュアル (32 ページ), ホームオーナーズマニュアル (16 ページ), インストレーション・マニュアル (29 ページ)

1. Install the "Z" Mounting Bar and Top Clips

Each cabinet is shipped with an aluminum "Z" mounting bar

which mounts to the wall to support the weight of the cabinet.

The bar should be installed in the center of the bottom brace (if

applicable).

Use a pencil to mark the wall where the bottom of the cabinet

will be located. Use a level to draw a horizontal line the length of

the mounting bar. If installing multiple cabinets side-by-side, use

a level to draw horizontal lines for each "Z" mounting bar.

Place the bottom edge of the "Z" mounting bar against the

horizontal line. Drill a minimum of three evenly spaced 7/32"

holes into the "Z" mounting bar through the indentations (holes

should line up with a stud behind the wall if no header was

installed).

NOTE: Use the plastic anchors supplied if no brace was placed in

the wall. Make sure each "Z" mounting bar has a minimum of three

anchors for each cabinet.

Use the #10 x 2" pan head thread cut screws (supplied) to secure

the "Z" mounting bar to the wall.

Locate the three top clips for the cabinet and slide the clips into

the groove located in the channel on the top side of the cabinet.

Kohler Co.

1010988-2-C