- ページ 7

室内装飾品 Kohler VEIL K-21800T-XのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler VEIL K-21800T-X 8 ページ。 Bathroom furniture

ページを印刷する

C. Install The Water And Electricity System

1. Have the water system connected and installed by a professional plumber to

avoid any leakage.

2. Have the power bus at the back of the cabinet connected with the reserved

line on the wall by a professional technician (see figure 9) to avoid electric

leakage.

3. After the procedures stated in 1 and 2 above are completed, lift the backboard

to the location shown in Figure 9. Turn the stopper by 90° to fix the backboard.

4. Open the cabinet door. Place the laminate glass onto the support.

D. Adjust

1. Adjust the cabinet door (see the figure below).

2. Adjust the adjustable feet. Check whether the bottom of each of the four metal

feet closely contacts the floor. If not, turn the adjustable feet counterclockwise

so that the bottom closely contacts the floor.

E. Introduction Of The Lights

1. Configure the lights. (See the figure below.)

2. Function Of The Lights

The background lightings are centrally controlled by the suite controller.

Status of the task lighting: When the door is closed, the light gradually turns

off; when the door is opened, the light gradually turns on.

Transparency control of the glass door: Wave your hand in front of the sensor

(see the figure above), the glass becomes transparent; wave your hand again

in front of the sensor, the glass becomes murky.

3. For detailed control of the background lightings, see the light introductions of

the VEIL Suite.

1356428-T01-A

Fig. 12 图 12

氛围灯1

Background Lighting1

可透明可雾化玻璃

Glass With Transparent/Murky

Fig. 13 图 13

C. 水电安装

1. 由专业人员连接并安装上下水，确保无渗漏。

2. 由专业电工将浴柜后部的电源总线与墙面预留的电线（图 9）连接起来，确保安

全无漏电。

3. 安装好后，参考上述图 9 中，将后背板升起，并转动背板挡块 90 度，固定住后背板。

4. 最后打开柜门，将层板玻璃放入层板拖上。

D. 调节

1. 柜门调节（见下图）

2. 调节脚调节。检查四个金属脚底部是否与地面紧密接触，如未接触请逆时针旋

转调节脚，使其与地面紧密接触。

E. 灯光功能介绍

1. 灯光配置。（见下图）

氛围灯2

Background Lighting2

柜体内部

Inner

门板玻璃控制器

Sensor For Glass Door

2. 灯光功能

氛围灯由套件控制器统一控制。

工作灯光状态：门关闭灯渐灭；门打开，灯渐亮。

玻璃门板透明控制：扫一下控制器部位（见上图）玻璃透明，再扫一下玻璃变磨

砂状态。

3. 氛围灯详细的控制说明请参加维亚套件的灯光说明。

- 7 -

工作灯光

Task Lighting