- ページ 7

体重計 acaia PS001のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。acaia PS001 20 ページ。

Product Care Information

• You can charge the battery by plugging the USB cable into

any of the power supplies listed below:

• A computer

• A USB wall-charger with an output of 5 volts and 1 amp

• A DC car-charger with an output of 5 volts and 1 amp

• It takes about 3-4 hours to fully charge the battery from

empty. Try not to let the battery completely run out before

charging. Charge the battery as needed.

• A fully charged battery can provide up to 16 hours of

working time in normal brightness and up to 40 hours in low

brightness mode.

• To check remaining battery level, see "Battery Level

Indicator" section.

* Note: Using a "fast-charging" charging block or charging hub (a charging block/hub delivering

over 5v at 1A) could damage your Acaia scale's circuit board.

• When the scale is off, the remaining battery level can be viewed by pressing and holding

the power button until the battery level indicator is displayed.

• You can also check the battery level by connecting the scale to Acaia Apps.

Turn on scale

Turn on the Acaia

scale.

Tap Tare button

Make sure the scale

is in weighing mode

and the unit is set to

'gram', then tap the

'T' button rapidly.

See CAL display

Keep tapping the 'T'

button until 'CAL' is

shown on the

display.

Place a weight

(100 g/500 g/1000 g)

on the scale and wait

until the display

shows '_End_'.

Calibration is now

complete!