自動車アクセサリー A-Tach Mounts 50387のPDF 使用方法をオンラインで閲覧またはダウンロードできます。A-Tach Mounts 50387 2 ページ。 Designed for volvo xc40 2018-20

A-Tach # 50387

Designed for: Volvo XC40 2018 - 20__

For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE

attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the

mount will appear to be a little too big or small for the intended location. The vehicle mount must be

installed BEFORE a device holder is screwed onto the vehicle mount.

Once screwed together the products are considered used and non-refundable.

The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.

Once it is attached, it should remain attached until you would like to permanently remove it.

WARNING:

AVOID extreme heat conditions. It can damage the device and the mount.

(1) Clean the area where the mount will attach. The

mount will attach into the two seams illustrated

with the arrows in the photo above.

(3) Remove the covering from the tape. Insert the

thin top edge of the mount into the seam next to

the seam tool.

See additional instructions on the back side.

ST-2

NOTICE: A-Tach Mounts will not be responsible for

any damage to the vehicle due to the installation

and/or use of the product. The product has been

tested to fit securely to the listed vehicles.

Instructions are provided for your convenience.

You are responsible for the use of the product and

to determine if you have the skill to attach the

product without causing damage to your vehicle or

the product.

Read all instructions and view the photos before

attaching this product.

(2) Insert the thin edge of the seam tool into the

top seam to open the seam a little. The mount

should be installed in the center of the display

area.

(4) Insert the thin edge of the seam tool into the

top seam to open the seam a little. This is a very

tight seam but it WILL OPEN. It will help to ...

A-Tach

Mounts