- ページ 7

集塵機 AQC MAXIHYDRO MS-006のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AQC MAXIHYDRO MS-006 14 ページ。

Wet type dust collector

5 CHECK THE UNIT

Check to ensure that the inspection window, located at the discharge end of the unit is tightly

bolted.

6 THE FAN

Fit the fan to the outlet end of the collector. For the best performance of the fan, the length of

straight duct between the unit discharge and the fan inlet should be five times the inlet diameter.

Check that the fan is correctly installed and is firmly sealed.

Trial start fan to ensure that the rotation of the blades is correct, and that there is no vibration.

7 SET UP THE WATER SYSTEM

Connect water pipe to the unit's water control system. Check the water pipes by trial running water

through them, and tightening joints if necessary.

8 GENERAL INFORMATION

When the unit is operating the unit will be supplied. For sludge removal, the unit is supplied with a

sludge rake-out chute, for sludge removal, bring a container or dump truck under the chute, open

the rake-out door, use the supplied rake and slowly reach into the tank, pull the rake towards the

chute and continue up the slope and discharge sludge into the container, continue until the floor

seems free of sludge, remove container, replace rake-out door. Unit is ready to operate.

(IF PART OF SCRUBBER)

Once the water control system has been set correctly the

system should not be re-adjusted. This unit will give constant

efficiency and air flow.

WARNING!