- ページ 6

産業機器 a-TroniX PPS Solar flexのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。a-TroniX PPS Solar flex 8 ページ。 Flexible solar module

User Manual

a-TroniX PPS solar flex

3. Installation notes

When installing the a-TroniX PPS solar flex module, make sure that it is in direct sunlight

and free from shade for as long as possible.

In order to obtain the highest possible output, the solar module should be oriented

towards the north in southern latitudes and towards the south in northern latitudes.

The surface should be thoroughly cleaned and free of oil and dust before mounting

Material required:

Adhesive Glue (e.g. Sikaflex)

■

Caulking Gun

■

Putty Knife

■

Mounting:

Apply the adhesive to the back of the module in either horizontal or vertical lines.

■

Leave a gap of 5 cm between the adhesive and the outer edge of the module.

■

When applying the glue, try not to interrupt the glue line.

■

After applying the adhesive, place the module on the cleaned mounting surface and

■

apply even pressure to the entire surface of the module.

It is best to remove any glue that may escape from the sides with a spatula.

■

Do not use chemicals.

Do not move the module after bonding and allow the adhesive to cure completely.

■

NOTE:

Other mounting forms, e.g. attachment via the integrated eyelets are possible.

Page 6

Glue

09/2021