- ページ 18

コンピュータ・ハードウェア Aqua Computer Aquaduct 360 ecoのPDF 操作・組立マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Computer Aquaduct 360 eco 20 ページ。 Aquaduct eco series

AQUADUCT ECO

teen-pin power supply cable to the PC interface card and

nector of your PSU into the designated jack of

To start the PC without having it connected to the

motherboard you will now have to attach the sup-

plied ATX start plug to the 20pin or 24 pin ATX

power supply connector of the PSU. After you

have attached the plug to the PSU and turned on

the mains switch of the PSU, the aquaduct and its pump will power up.

Please note: Some high-power PSUs will not be able to power the aqua-

duct without further electrical load due to power regulation problems. In

this case, use a second (complete) PC or a separately sold PSU for

single components for the filling process. Alternatively, connect further

load like hard disk drives and optical drives to the PSU.

The pump of the aquaduct will now pump the coolant from the right

profile through all connected water cooling equipment and the level in

the right profile will fall. You will have to refill coolant according to the

level. After a short while, water will appear in the left profile and the

level will rise slowly until water flows back into the right profile via the

bridge. Refill coolant until the left profile is completely filled and only 2-

3 cm (about 1 inch) of air remains in the right profile, then reinsert the

sealing screw.

Important:

Important: If you hear rattling noises

Important:

caused by air inside the pump. You can accelerate the deaeration pro-

cess by carefully tilting the aquaduct. It is absolutely important that there

is always enough water in the right profile. Otherwise the pump will

draw in air. Since the used radial pump will stop working in this case,

the system then must be deaerated completely. To do this, it is necessary

to empty the system completely and refill it again.

ATTENTION:

ATTENTION: Before you put the PC hardware into operation, for

ATTENTION:

safety reasons the complete system must be checked for possible

leakages. Do not put the PC hardware into operation before you

have made sure that there are no water leakages! If components

have come into contact with water, do not put these into operation

before they are completely dry again!

- 18 -

from

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen

the PC interface card.

the pump, they are most likely

plug a con-