- ページ 2

ウォーター・ディスペンサー Aqua Cooler M11FのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aqua Cooler M11F 5 ページ。
Aqua Cooler M11F にも：取扱説明書 (13 ページ)

To ensure you install the unit easily and correctly, PLEASE READ THE FOLLOWING

INSTRUCTIONS BEFORE STARTING INSTALLATION. CHECK YOUR

INSTALLATION IS IN COMPLIANCE WITH PLUMBING, ELECTRICAL AND

OTHER APPLICABLE CODES. There are some simple diagrams to assist you in the

installation of the cooler on the last sheet of this booklet. After installation, leave these

instructions inside the cooler for future reference.

IMPORTANT INFORMATION ABOUT YOUR WATER COOLER

1. The water cooler is not intended for outdoor use.

2. All service work to be carried out by authorised Aqua Cooler service agents only.

Failure to do so will void the warranty on the water cooler.

3. Warranty will also be voided if installation is not carried out as detailed in the Aqua

Cooler installation instructions.

4. The thermostat is pre-set and non-adjustable for 10 degree water under normal

conditions.

5. The coolers are tested to meet accreditation standards. This cooler meets the

AS/NZS 1044:1995 EMC testing standards for electrical interference. They meet

the TYPE test MP52 plumbing standards for back flow prevention and they are

tested to meet IEC 60 335-2-24:97 plus amendments for electrical safety.

If you would like Aqua Cooler to install the system for you, please contact us at the

number on the cover of this booklet.

1. Ensure proper ventilation by allowing 75mm clearance on each side of the cooler.

2. Minimum water pressure is 100 kpa and maximum is 700 kpa. If the water pressure

exceeds 700 kpa a pressure limiting valve should be fitted. These are an optional

extra and are available through Aqua Cooler, if needed.

3. Install a 40 mm waste trap onto the waste outlet on the rear of the cooler - not

supplied.

4. Water in connection is secured via a ½" kinko nut and olive into the stainless

connection on the rear of the unit as per the diagram in this booklet. It is

recommended that a ½" shut off valve is installed at this point for the purposes of

future maintenance.

5. Turn on water supply and hold down bubbler and purge system of air until a steady

stream of water comes from the tap.

6. The tap needs to be adjusted for the correct water flow in relation to the local water

pressure. On the side of the tap is an inner and an outer screw. Once you have

established a steady water flow adjust the INNER screw until the stream is in the

centre of the stainless steel top.

7. Check all connections for water leaks.

8. Plug the cooler into the building electrical supply. The unit will start automatically.

INSTALLATION INSTRUCTIONS

FOR THE INSTALLER

INSTALLATION