- ページ 7

水システム Aqua Cooler AC-NNEBFPGのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aqua Cooler AC-NNEBFPG 11 ページ。 Surface mounted bottle filler conversion

INSTALLATION CONT.

Attach one of the drain elbows to the drip

tray stem. Insert the drainpipe provided into

the elbow and then attach another elbow onto

the pipe. Use the remaining drainpipe and

connect the drip tray drainage system to the

installed P-trap.

NOTE: Drainpipes will need to be positioned

and cut to length as needed.

Assemble NNEBFEZ wrapper to the installed frame. Rest the alcove on the drip tray

and ensure the wrapper walls rest OUTSIDE of the frame and side brackets.

NOTE: The drip tray will hold the weight of the wrapper but it is recommended to

keep a hold on the unit during installation for safety.

Your Partner in Cool.

INSTALLATION CONT.

If the outer edge of the drip tray is not properly aligned, loosen the screws on the back of the

drip tray support bracket and slide the bracket forward or backward as needed. Then retighten

the screws.

Once the wrapper has been installed, loosen the side bracket mounting screws until the bracket

can be slid up and down. Adjust the bracket until the mounting hole screws through the slot and

then drive in one of the #8 Torx screws and then tighten the two #10 mounting screws.