- ページ 10

リフティングシステム Aqua Creek Ambassador F-PPXRD-NA-02のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek Ambassador F-PPXRD-NA-02 18 ページ。 Pool lift

Pull-out Legrest Installation Instructions

3. Orient the pull-out legrest as shown in FIGURE 11 and slide the

PLASTIC GUIDE/SPACER into the chair support tube. Tap the PLASTIC

GUIDE/SPACER with a hammer or mallet until fl ush with the end of

the support tube. The threaded hole in the bottom of the PLASTIC GUIDE/SPACER should line-up

with the hole drilled in the chair support tube. Install the lock washer and 1/4 -20 x 1/2 inch cap

screw from underneath and tighten until snug.

PLASTIC GUIDE/SPACER

The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put

the pad up and down to make sure everything works smoothly.

LEGREST STOWED

1" SQ. TUBE

CHAIR SUPPORT TUBE

PULL-OUT LEGREST

PLASTIC GUIDE/SPACER

FLUSH WITH 2" SQ. TUBE

FIGURE 11

PULL LEGREST OUT

SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION

1/4" LOCK WASHER, SS

1/4-20 X 1/2" CAP SCREW, SS

FLIP LEGREST UP AND PIN

SLOT

You Will Need:

•

Flat head Screwdriver

•

Hammer / Mallet

•

5/32" Allen Wrench

Revised 6/28/18