- ページ 10

洗濯機 Dexter Laundry 400 EXPRESSのPDF オーナーズ・ブックレットをオンラインで閲覧またはダウンロードできます。Dexter Laundry 400 EXPRESS 13 ページ。 25lb capacity computer control coin-op washer installation & operation instructions

ページを印刷する
To change a feature of the wash cycle, push and hold the Hot temperature button and then push
the programming pushbutton on the controller. The Washer mush be in the Idle mode to enter
the Wash Cycle Programming mode. When entering the cycle programming mode the Bleach
LED will start to blink and continue to blink as long as you are in the Cycle Programming mode.
The display will show "C 0". This is the default cycle number.
Note: The washer can be returned to the factory default settings by holding
the right Warm button and then pressing the left Warm button. The
display must show "C 0" to do this. When the cycle default values are
loaded, the washer will automatically exit the programming mode.
Note: The Wash Cycle programming mode will automatically exit and return to
the Idle mode if no buttons are pushed for one minute.
To change the washer cycle, push the Hot temperature button once. The display will change to
"C 1", indicating cycle one is selected. The temperature buttons are used to make changes to
the program. In the program mode, the buttons will do the following:
When the display shows "C 1", push Enter. The display will show "b" and the PreWash mode
light will blink. Use the Up/Down buttons to move to the bath that will be changed. As
Up/Down buttons are pushed, the next bath mode light turns on.
When the Up button is pushed, the lit bath mode changes from Prewash to Wash. With each
additional push of the Up button, the lit bath mode changes from left to right: Prewash, Wash,
Rinse and Final Rinse. As there are two possible Rinse bathes, for Rinse1 the Rinse LED and
the display changes to "b" in the left digit and "r1" in the two right hand digits. For Rinse2, the
display changes to "b" in the left digit and "r2" in the two right hand digits. Note that the Spin
light is not used. When the Down button is pushed, the lit bath mode changes from Prewash to
Final Rinse, etc. There is a wrap around feature in both directions. When the desired bath mode
light is on, push Enter.