- ページ 4

リフティングシステム Aqua Creek F-03EZPLのPDF 設置・組立・操作説明書をオンラインで閲覧またはダウンロードできます。Aqua Creek F-03EZPL 12 ページ。 Ez pool lift

EZ POOL LIFT ANCHOR INSTALLATION

NOTE: The EZ Pool Lift comes standard with a 6" deep anchor socket that is

installed into a concrete deck. Anchor options include a surface mount anchor

and a wood deck anchor system both purchased separately. The EZ Pool Lift

standard 6" anchor system can be installed in an existing pool deck (Retro-fit

installation) or when pouring a new concrete pool deck (New construction

installation). If the anchor has already been installed you can move on to the

assembly section of this manual that is appropriate to the lift you purchased.

EZ POOL LIFT RETRO-FIT ANCHOR INSTALLATION

NOTE: The concrete deck around the anchor system should be a minimum of 8"

thick and should be reinforced with #4 reinforcing bars spaced on 10" centers in

each direction. The total concrete pad area should be at least 60" wide

(measured away from the pool edge) and 60" long (parallel with the pool edge).

Tape Measure

4" [10 cm] Core Drill Bit

2-part Epoxy or Hydraulic Cement

Felt Tip Marking Pen

STEP 1:

Determine the best location for the lift. Be sure to mount the lift at a location that provides

at least 42" [107 cm] and no more than 48" [122 cm] from deck level to the bottom of the

pool. Make sure the location includes enough clear deck space to easily transfer into the

lift seat. Keep in mind this lift will require assistance from another person to operate and

you should locate it in an area that can accommodate another person. The lift should also

be located so as to provide at least 6' [1.8 m] of unobstructed deck to each side of the lift

to accommodate easy maneuvering of the lift over the

water and back.

STEP 2:

Locate the concrete anchor socket that came with your

lift. Be careful to not lose the protective cap on the

anchor. This will be used to keep dirt and debris out of

the socket when the lift is not installed in the anchor.

STEP 3:

The setback to the center of the anchor must be no less

than 12" [30.5 cm] and no more than 20" [51 cm] from the pool wall. The anchor location

must also be at least 6" [15 cm] from any control joint or edge of concrete slab. Measure

the location out using your tape measure and marking pen. (Reference the drawing on the

next page for details).

EZINST-6/27/14

REQUIRED TOOLS (Core Drilling Method)

Core Drill

Electrical tape

Small Carpenters Level

Vacuum or compressed air source

CONCRETE ANCHOR

SOCKET

Page 4 of 12