- ページ 9

リフティングシステム Aqua Creek F-03EZPLのPDF 設置・組立・操作説明書をオンラインで閲覧またはダウンロードできます。Aqua Creek F-03EZPL 12 ページ。 Ez pool lift

OPERATING INSTRUCTIONS –EZ POOL LIFT

NOTE:



FOR SAFETY, CHECK FOR WORN PARTS AND LOOSE BOLT CONNECTIONS PRIOR

TO EACH USE.



ALL OPERATORS SHOULD BE FAMILIAR WITH ALL LIFT COMPONENTS AND THEIR

INTENDED USES.



OPERATORS SHOULD ALSO BE COMFORTABLE WITH ALL LIFTING PROCEDURES

BEFORE ATTAMPTING TO LIFT A PERSON WITH THE LIFT.

The EZ Pool Lift was not designed to be a self-operable unit and as such requires the use

of an operator to assist the lift user with the transfer into and out of the pool.

There are two methods of loading the lift user into the harness. The method of loading will

depend on the physical ability of the lift user. If the user has very limited use of his upper

body, it will be necessary to follow the procedure as outlined below. If the user is

physically able, he can simply place himself into the harness without need for assistance.

However, once in the harness, it will still be necessary for an operator to assist with the

transfer into or out of the pool.

 With the lift in the up position and the boom arm located over the deck, roll the user

under the lift and engage the brakes on the wheelchair.

 With the user facing the assistant, place the mesh seat sling under the seated user

while still in the wheelchair.

 Attach the chain to the mesh sling and the overhead hanger bar. There should not

be any slack in the chain at this time.

 Make sure all chain connections are secure and the mesh seat sling is level on

each side.

 Raise the user by pumping the hydraulic ram handle until the desired height is

achieved. The user should just clear the wheelchair. Move the wheelchair out of

the way if needed.

 Rotate the lift so that the user is above the pool, keeping one hand on the boom and

one hand on the user to stabilize them.

 Lower the user into the water by pressing the handle

towards the ram until it depresses the release pin. The

hydraulic ram automatically controls the rate of descent for

safety and control.

 This procedure is repeated to remove a user from the water.

 When the lift is not in use, remove the sling, hanger bar and

mast from the anchor socket and replace the protective

anchor cap.

EZINST-6/27/14

Page 9 of 12