- ページ 13
洗濯機 Dexter Laundry HIGH SPEED 25LB WASHERのPDF 取付・取扱説明書をオンラインで閲覧またはダウンロードできます。Dexter Laundry HIGH SPEED 25LB WASHER 14 ページ。 High extract washer 25 lb (11.4 kg) capacity stackable on-premise laundry computer control
ページを印刷するRAPID ADVANCE MODE
To enter the Rapid Advance mode, turn the key counter-clockwise (CCW). The Rapid Advance
setting is not marked next to the key, but turning the key CCW until it stops selects this mode. The
Rapid Advance mode can be entered from either the Idle mode or during the cycle. If the cycle has
not yet started, press the "START" button. To rapid advance to the next step in the wash cycle, push
both the "UP" and "START" buttons at the same time. The display will show an "Ad" (advance) in
the display. The washer will advance to the next bath segment. The water will drain before the
advance will occur and the time displayed may not be accurate.
Notes:
•
The indicator lights will show to which segment the cycle has been advanced.
•
The cycle will continue in rapid advance mode even if the key is turned to "RUN" and/or
removed.
•
Rapid advance cannot skip the final 1-minute tumble of the cycle, and the door lock may remain
activated for a couple minutes after the cycle has been completed.
•
The chemical injection signals will not operate in Rapid Advance mode.
To end the cycle and exit the Rapid Advance mode without waiting for the time to count down, push
and hold the STOP button for 5 seconds or more.
INJECTION SOURCE DETAILS
The washer control may be programmed to send output signals for a chemical injection system.
There is a separate terminal block for connection of the external injection signals. For the injection
sources, program codes 0 through 6 are as shown in the table below. See the ELECTRICAL section
for more information.
Recommended
Connections
Detergent
Bleach
Sour/Softener
Dexter
Controller
Programmed
Signals
Starch
Injection
Terminal Block
Circuits
1
A
2
B
3
C
4
D
5
A and B
6
C and D
0
None