- ページ 9

リフティングシステム Aqua Creek F-702RLSDDのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek F-702RLSDD 16 ページ。

Pull-out Legrest Installation Instructions

The PULL-OUT LEGREST ASSEMBLY is designed to fit under the standard Aqua Creek chair, and is installed

inside the 2" square tubing that supports the chair from underneath. Installation is the same for every lift,

Ranger lift is shown in picture below. To install the pull-out leg-rest;

1. With a flat-blade screwdriver, pry off the 2" square plug from the end of the 2" square tube of the seat arm.

SEE FIGURE 8.

2. Drill a 9/32" hole at the location indicated in FIGURE 9 through the bottom of the chair support tube. Drill

only through the bottom of the tube. Remove the burrs from the hole before installing the legrest assembly.

2" SQUARE

PLUG

DRILL

9/32" HOLE

(BOTTOM OF CHAIR SUPPORT TUBE)

(SEE DRAWING TO THE RIGHT)

SEAT

SEAT ARM

FIGURE 8

DRILL

9/32"

3/4"

(THIS SIDE)

CHAIR SUPPORT TUBE

(BOTTOM VIEW)

FIGURE 9

Revised 9/19/17