- ページ 8

モビリティ・エイド Aqua Creek F-700RLのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek F-700RL 14 ページ。

STEP 6: INSTALL THE FOOTREST

Locate the FOOTREST ASSEMBLY and install it on

the seat as shown below. The QUICK RELEASE PIN is

attached to the SEAT ASSEMBLY with a lanyard (cable).

Pull out the pin and slide the FOOTREST ASSEMBLY

into the slot and line up one of the holes on the

FOOTREST TUBE with the hole for the pin. Push the

pin back into the hole and through the hole in the

FOOTREST TUBE to hold the FOOTREST ASSEMBLY

in the desired position. To re-adjust the FOOTREST

simply pull out the pin and select a new hole on the

FOOTREST TUBE.

STEP 6

SEAT

ASSEMBLY

Not Seated

Revolution Assembly Instructions

QUICK

RELEASE

FOOTREST

TUBE

(ADJUSTABLE)

STEP 7: INSTALL 24V BATTERY & HANDSET

Locate the 24V battery, the battery charging unit

and the handset control. Charge the battery for 24

hours then install it on the bracket above the control

box as shown on PHOTO 7. Plug the handset control

into the control box as shown in the figure and in

the photos below. Press firmly to make sure the plug

is fully seated as shown below.

THE LIFT WILL NOT FUNCTION IF THE HANDSET

PLUG IS NOT FULLY SEATED OR IF THE BATTERY IS

NOT PROPERLY ALIGNED.

CONTROL

24V

CONTROL

BOX

Seated

STEP 7

Revised 8/11/16