- ページ 10

リフティングシステム Aqua Creek Products ACF-SCTXLのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek Products ACF-SCTXL 15 ページ。 Pool lift

Scout Excel Assembly Instructions (cont.)

The CHAIR ASSEMBLY will arrive attached to the CHAIR ARM adjusted to its highest position.

To adjust the CHAIR ASSEMBLY to a lower position remove the hardware as shown in FIGURE G.

Slide the SEAT ASSEMBLY to its desired position (in 4" increments) and reinstall the hardware. The

maximum adjustment is 16".

DO NOT ATTACH THE CHAIR ASSEMBLY ANY LOWER THAN THE BOTTOM TWO HOLES – ALWAYS USE

THE TWO (2) SUPPLIED BOLTS TO ATTACH THE CHAIR ASSEMBLY TO THE CHAIR ARM!

NOTE: For most applications the seat will be installed in its lowest position. For applications where a

wall or curb must be cleared the seat should be installed in a higher position.

With the lift fully assembled and anchored, run the lift completely out and back in 3-5 times,

without weight, for the lifts "break in" cycle period.

CHAIR ARM

ADJUSTMENT

HOLES IN 4"

INCREMENTS

(16" ADJ. RANGE)

CHAIR ADJUSTED

TO LOWEST

POSITION

3/8" X 2"

SHOULDER BOLT

5/16" X 4 1/2"

HEX BOLT

5/16" FLAT

WASHER

3/8" FLAT WASHER

3/8" NYLOCK

NUT

5/16" NYLOCK

NUT

5/16" FLAT

WASHER

FIGURE G

Revised 4/20/20