- ページ 6

リフティングシステム Aqua Creek Products Ambassador F-PPXRD-R-04のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek Products Ambassador F-PPXRD-R-04 18 ページ。 Reverse pool lift

ページを印刷する

Anchor Installation: Saw-Cut Retro-Fit

You Will Need:

• Concrete saw with diamond blade

• Tape measure

• 4' long straight edge or chalk line

• Sledge hammer

• Cold chisel

• Large adjustable wrench

ANCHOR INSERT (3)

FIGURE 4

ANCHOR JIG-PLATE

#10-24 NYLOCK NUT

1/4" FLAT WASHER

1/4" X 3/4" PAN-HEAD

SIDE VIEW (ASSEMBLED)

51"

FLUSH W/ DECK

2500 PSI MIN.

DRILL & EPOXY INTO EXISTING

SLAB (4" MIN EMBED)

*SETBACK DIMENSIONS ARE FOR FLAT DECK APPLICATIONS.

FOR SLOPED DECKS OR OTHER FEATURES, CONTACT AQUA

CREEK BEFORE INSTALLATION.

• Torpedo level

• String Line

• Concrete & concrete

fi nishing tools

• #5 rebar

1" X 4"

#10-24 X 3/4"

CAP-SCREW

1" HEX NUT (6)

Cu BONDING LUG

12"

51"

TYP

22 1/2" MIN

38" MAX

8-AWG SOLID-

COPPER WIRE

(ATTACH TO

BONDING-GRID)

BONDING

LUG

LABEL

POOL WALL OR

REBAR

FURTHEST

OBSTRUCTION

#5 REBAR E-W (5 PCS)

FIGURE 5

NOTE: 2500PSI MINIMUM STRENGTH 6"

THICK OR MORE CONCRETE IS REQUIRED

1. Remove one nut from each anchor insert.

Place the anchor inserts through the larger hole

of the anchor jig plate. Thread the removed nuts

back onto the anchor inserts. The anchor plate should be

sandwiched between the two nuts on each anchor insert.

SEE FIGURE 4

2. Mark out a section of the pool deck that you are

removing. Plan on removing at least

4 feet 3 inches by 4 feet 3 inches.

3. Cut along your marks with a diamond blade concrete

saw.

4. Using the sledge hammer break up the concrete within

the cut area and remove the pieces.

5. Install rebar in the open area of the deck. Tie the rebar

into the existing deck if possible.

6. Set the anchor system in place. For ADA

compliance and clearance, make sure the center

of the large anchor jig plate hole is between 22.5

and 38 inches from the pool's edge.

7. Using the string line or a straight edge & level,

confi rm the top of each anchor body is level with

the FINISHED deck surface. Each anchor body can

be individually adjusted by turning the nuts with

a large wrench.

8. Bond the anchoring system according to your

local code requirements by using the bonding lug

on the anchor plate.

680.26)

9. Pour concrete and fi nish the pool deck surface.

10. Once the concrete has cured, the lift is ready

to be mounted to the anchoring system.

SEE FIGURE 5

SEE FIGURE 5 (See NEC Article

Revised 5/27/21