- ページ 6

リフティングシステム Aqua Creek Products F-MTY2PDSのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek Products F-MTY2PDS 6 ページ。 Mighty lifts shallow deck pedestal

Anchor Installation: Saw-cut Retro-fit

You Will Need:

• Concrete saw with diamond blade

• Tape measure

• 4' long straight edge or chalk line

• Sledge hammer

• Cold chisel

• Torpedo level

• String Line

• Concrete & concrete finishing tools

• #3 rebar

Remove 1 nut from each anchor insert. Place the anchor inserts through the larger hole of the anchor jig

plate. Thread the removed nuts back onto the anchor inserts. The anchor plate should be sandwiched between

the two nuts on each anchor insert. SEE SECTION D-D

Mark out a section of the pool deck you are removing. Plan on removing at least 5'-6" x 5'-6" x 6" deep. It

must be reinforced with 7 sticks of #3 rebar E-W, 3" clear (min) from the top and bottom of the footing.

Cut along your marks with a diamond blade concrete saw.

Using the sledge hammer, break up the concrete within the area you cut and remove the pieces.

Install rebar in the open area of the deck. Tie the rebar into the existing deck if possible. SEE FIGURE 03

Set the anchor system in place. Make sure the center of the large anchor jig plate holes aren't set back

further than the max distance provided on page 3.

Using the string line or a straight edge, make sure the top of each anchor body is level with the

deck surface. Each anchor body can be adjusted individually by turning the nuts with a large wrench.

Bond the anchoring system according to your local code requirements by using the bonding lug on the

anchor plate. SEE FIGURE 03 (See NEC Article 680.26)

Pour your concrete and finish the pool deck surface. SEE SECTION D-D

10.

Once the concrete has cured, your lift is ready to be mounted to the anchoring system.

SEE FIGURE 04 & 05

FINISHED

6 OF 6

10/26/2020 12:35:29 PM