- ページ 17

パーソナルケア製品 A.H.Beard GeniusのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。A.H.Beard Genius 20 ページ。 Adjustable base

setting up two bases

If simultaneous operation of two bases is desired, use the SmartSync

STEP 1

Unplug base from power source .

STEP 2

Disconnect the power-down box cable from each control box . Make

note where the cable was plugged in .

STEP 3

Connect the male end of each sync cord to control box . Insert it into

the same port that you disconnected the power-down box from in

Step 2 .

Control Box

Power-Down Box

electronics of both bases together.

STEP 4

Connect each power-down box male connection to the sync cord

female connection (Refer to the illustration below) .

STEP 5

Plug base back into the power source .

STEP 6

Check to ensure all cords are securely attached . Both remotes will

now operate both bases simultaneously (If the remotes become

unpaired, see page 13) .

Sync Cord

Splitter

Cord to connect the

™

SERIAL PORT

Control Box

Power-Down Box