- ページ 5

照明器具 Aqua Creek Products MIGHTY 400-BLUEのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek Products MIGHTY 400-BLUE 13 ページ。

LIFT THE MIGHTY 400 MAST ASSEMBLY FROM THE SHIPPING

CONTAINER. INSERT THE 1.90" [48mm] POST OF THE MAST

ASSEMBLY INTO THE DECK ANCHOR. EASE THE MAST ASSEMBLY

DOWN UNTIL IT RESTS ON THE DECK SURFACE. ROTATE THE

BASE UNTIL THE FIXING ANCHOR HOLE LINES UP WITH THE

FIXING ANCHOR. INSTALL THE 1/2"-13X1 1/2" HEX BOLT AND

WASHER (PROVIDED IN THE STOCK BOX) TO HOLD DOWN THE

LIFT. TIGHTEN THE BOLT.

SLIDE THE SEAT CRADLE

ASSEMBLY UP THROUGH THE TOP

CASING OF THE MAST ASSEMBLY AND

CONNECT USING THE SUPPLIED 5/16"

HEX BOLTS, WASHERS AND NYLOCK

NUTS. FOR STANDARD POOL

CONFIGURATION THE SEAT CRADLE

WILL BE CONNECTED AT THE TOP TWO

HOLES. HOWEVER, THE SEAT CRADLE

CAN BE ADJUSTED UP TO 6" HIGHER,

IN 2" INCREMENTS, IF THERE IS A

NEED FOR IT.

WITHOUT BOTH HEX BOLTS

INSTALLED!

NOTE: BE CAREFUL NOT TO

OVERTIGHTEN BOLTS. OVER-

TIGHTENING CAN CAUSE DAMAGE AND

COMPROMISE THE SAFETY OF YOUR

LIFT.

FIXING ANCHOR HOLE

POST

FIG. 01

PRODUCT ASSEMBLY

NEVER USE THE LIFT

TOP CASING

SEAT CRADLE

Aqua Creek Products

FIG. 02

9/28/2022 1:39:29 PM PAGE - 5