- ページ 12

モビリティ・エイド Aqua Creek Products F-MTY600-TのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek Products F-MTY600-T 14 ページ。 Pool lift

PROCEDURE

Check battery level indicator on control box

Run the lift through a complete test cycle (fully

extend actuator) to verify it is functioning properly

Wash lift with fresh water and dry with clean, soft,

non-abrasive cloth

Recharge battery

Visually inspect lift for damage, corrosion, and loose

or missing hardware

Check all contact points for damage and/or corrosion

Repair, clean, and apply dielectric grease to all

contact points

Thoroughly clean lift frame and apply a liberal coat of

car wax to maintain the lift's finish

Check all warning and cautionary labels to make sure

they are not faded or worn. Replace as needed.

PROPER CARE NOTES

• Use only fresh water to wash your lift. Do not wash with pool water.

• Use only clean, soft, non-abrasive cloths on your lift.

• Do not store lift in pump room or near chemicals.

• Do not allow children to play on or around this lift.

• When cleaning the lift do not spray water directly on control box or battery.

• The lift may need to be bonded according to local code requirements.

STAIN REMOVAL TIPS:

To remove stubborn stains from finish, spray affected area with mild dish soap, rub

briskly with a 3M Scotch Brite™ pad. Use white epoxy paint to touch up the finish. Apply

wax to protect when dry.

Proper Care of Pool & Spa Lifts

For service and/or replacement parts, contact Aqua Creek Products

Toll free: (888) 687-3552

BEFORE

DAILY

EACH USE



WEEKLY MONTHLY



Revised 4/23/19