- ページ 8

モビリティ・エイド Aqua Creek Products Mighty 400のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Creek Products Mighty 400 15 ページ。 Pool lift

TOOLS REQUIRED:

1/2" WRENCH (2)

Lift the Mighty 400 MAIN ASSEMBLY from the shipping container. Insert the 1.9" [48mm] post

of the MAIN ASSEMBLY into the deck anchor (FIGURE A, PAGE 6). Ease the MAIN ASSEMBLY down

until it rests on the deck surface. Rotate the base until the fi xing anchor hole lines up with the

fi xing anchor. Install the 1/2" x 1 1/2" hex bolt and washer to hold down the lift. Tighten the bolt.

Remove all of the shipping materials from the lift. Slide the CHAIR AND CHAIR ARM ASSEMBLY

up through the top casing of the MAIN ASSEMBLY and connect using the supplied 5/16" hex bolts,

washers and nylock nuts. For standard pool confi guration the CHAIR ARM will be connected

at the top two holes. However, the chair arm can be adjusted up to 6 inches higher, in 2 inch

increments, if there is a need for it. NEVER USE THE LIFT WITHOUT BOTH HEX BOLTS INSTALLED!

5/16" X 3"

HEX BOLT (2)

MIGHTY 400 LIFT

MAIN ASSEMBLY

Mighty 400 Assembly Instructions

WARNING:

NEVER LIFT THE MAIN ASSEMBLY

USING THE LINEAR ACTUATOR AS A HANDLE! USE

AT LEAST TWO PEOPLE TO LIFT.

5/16" NYLOCK NUT (2)

5/16" FLAT WASHER (4)

MIGHTY 400 CHAIR

AND CHAIR ARM

Revised 6/24/20