- ページ 11

CDプレーヤー AVM EVOLUTION CD 3.2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AVM EVOLUTION CD 3.2 14 ページ。
AVM EVOLUTION CD 3.2 にも：取扱説明書 (14 ページ)

3 Advanced settings

The personal setup offers you a range of settings to individualize the device according to your personal

needs. To enter the personal setup menu, please switch off your device on the rear of the unit at the

mains switch (29). Keep the PROG button (4) pressed while you switch on the unit again. As soon as

the display shows *** personal setup *** menu you can release the PROG button (4).

When the personal setup is active you can select the desired function using the option keys (2, 3). Use

the Skip buttons (13, 14) to apply changes to a selected function. EXIT exits the personal setup and

stores the settings.

Choose between a fixed ("fixelevel") or a variable ("variable") output level of the analogue outputs (16-

18). If "variable" is selected, the output level of the analogue outputs of your CD 3.2 or CD 5.2 can be

controlled by pressing the VOLUME buttons on your RC 3 remote control. In standard operating mode

an information on the current output level state is displayed in the upper-middle part of the display (e.g.

VOL 75). FIX indicates a fixed output level setting.

Sets display brightness between 25% and 100%.

NOTE: The setting 100% can lead to "burn in" effects on the display if the unit is operated in this

setting for a very long time. So please switch the unit to stand by, if not in use.

When AUTOPLAY is ON, your CD player will start playing automatically every time a new CD is

inserted. If AUTOPLAY is OFF, the unit will read the TOC (Table Of Content) of the inserted disc and

then go to STOP mode.

Deactivate unused inputs ("SKIP"). The unit will then skip these inputs when the option keys are

pressed (2, 3) or if you select the inputs via the RC 3 remote control.

You can individually set the names (max. 8 characters) of the different sources shown in the display (8).

Proceed as follows:

Press < or > (2,3) to select the input. Press REPEAT (6) to select the position and I<< or >>I (13,14) to

define the character (holding the key pressed changes the character every half second).