- ページ 10

CDプレーヤー AVM EVOLUTION CD2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AVM EVOLUTION CD2 19 ページ。 Cd-player evolution

CONNECTION TO DIGITAL RECORDING DEVICES

The C02 has various outputs. This means that in addition to the connection

a D/A converter or the dig-

ital input of an amplifier the unit can be connected to the digital input of a OAT recorder or other digital

recording equipment.The cable connections should be undertaken as described above. Please also pay atten-

tion to the operating instructions of your digital recording apparatus.

INITIAL OPERATION/BASIC FUNCTIONS

SWITCH ON POWER SUPPLY

Switch the C02 and other equipment on and set the input selection switch of your amplifier or D/A con-

verter to the input to which your C02 is connected.

Subsequent initially switching on your power supply switch (2) the C02 requires about S seconds until all

working voltages have built up and the internal processor has checked all functions. During this time "5 SEC

WARM UP" appears in the display.

TIP: If the display remains blank after initially switching on the C02 unit, although the control LED (I) is illu-

minated, try pressing the DISPLAY OFF button (13).

IMPORTANT: Even though the unit is switched off it is still connected to the power supply.The mains plug

should always be disconnected to separate the unit from the power supply on occasions such as thunder-

storms, or long absence.

OPEN THE CD TRAY, INSERT

CD,

CLOSE TRAY

Following the warm-up and testing phase the display shows "STOP".You can now open the tray by pressing

the button OPEN (9).

Place the CD with the glossy side facing downwards (printed side facing upwards) in the depression of the

turntable.

TIP: Remove any particles (dust, crumbs) from the surface of the CD with a soft brush or a lint free cloth

prior to insertion.

Further pressing of the button OPEN (9) causes the C02 to close the tray with the CD. After a few sec-

onds the display (7) will indicate at top left the number of titles on the CD and to its right the total playing

time in minutes and seconds (separated by a colon). After approximately 10 seconds the title number "0 I"

and the playing time "00.00" is displayed.

TIP: Opening the tray will cancel all pre-programmed functions (REPEAT, title selection with PROGRAM,

TIME etc).