照明器具 Dextra AME2 NM3 LS3のPDF インストール・リーフレットをオンラインで閲覧またはダウンロードできます。Dextra AME2 NM3 LS3 2 ページ。

AME2 M3/NM3 LE3/LS3 Installation Leaflet

Voltage: 220-240V / 50-60Hz

LED Power: 4.5W (1W for NM3)

Output: 460 lm (160 lm for NM3)

Battery: Li-FeP04 18650 3.2V 1500mAh

Operating Temperature: 0°C - 40°C

BEFORE installation, the electrical supply and battery pack MUST be disconnected.

Remove the diffuser by loosening the two screws.

Drill out the cable entry point on the rear of the

housing. Ensure a suitable cable gland is used in order

to maintain the IP65 rating.

Pass the cable through the cable gland, and wire

directly into the terminal block. Proceed to connect

the battery.

DIL-0300-0066

WARNING - THIS LUMINAIRE MUST BE EARTHED

This luminaire has been tested and is manufactured to comply with BS EN

60598 : specification for general requirements and tests. It should be installed by

a suitably qualified person in accordance with IEE.

CAUTION: there is a potential risk of electric shock from the LED boards when

the product is operational with the cover removed.

NOTE: INSTALLATION AND OPERATION OF THE LUMINAIRE BEYOND ITS

SCOPE OF SUPPLY WILL INVALIDATE THE WARRANTY.

Release the tray by pushing the tabs outwards. Pull

the tray down, away from the body.

Drill through the two fixing points on the back face.

Ensure the fixing points are adequately sealed in

order to maintain the IP65 rating. Secure the

- M3

- NM3

Refit the diffuser to the body, and secure in place

Revision - B

luminaire with two screws.

using the two screws.

25/04/2022