- ページ 6

モニター Fencee MX10のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Fencee MX10 16 ページ。 Remote monitoring of fence parameters
Fencee MX10 にも：ユーザーマニュアル (16 ページ)

6. DESCRIPTION OF CONTROLS

Power supply

The Monitor is powered by two C-LR14 batteries, which must be inserted through the back

cover and the correct polarity must be observed. It is recommended to install alkaline

batteries for longer life. The battery status is indicated in the Gateway as a percentage.

Battery life is about 1 year.

Control

The device is controlled by the included magnet, which must be attached to the target on

the side of the MX10 Monitor. When the magnet approaches, the status of the Monitor is

indicated by an LED diode:

Red = off

Green = on

If no LEDs light up, the batteries need to be checked and replaced.

Switching on

Place the magnet on the target for about two seconds.

The Monitor first beeps and lights up the red indicator LED. Subsequently, the Monitor will

flash green and beep 3 times. The Monitor is now on and indicates its ON status by regular

flashing green LED. When the Monitor is ON, it indicates its activity for a limited time of

2 minutes to save battery power.

Shutdown

By bringing the magnet closer to the target for about two seconds.

The Monitor first beeps and lights up the green indicator LED.

Then the Monitor will flash red and beep twice.

The Monitor is now turned off.

TIP:

You can check the status at any time - by bringing the magnet

closer to the target for <1s. The colour of the LED indicates the

status: red = off, green = on.