- ページ 8
コントローラー AB Quality SD3000 PLUSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。AB Quality SD3000 PLUS 12 ページ。 Dc drive regulator
ページを印刷するChecking the Indicators
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Engineered by
GP
P.M. FLT
FDBK OK
LP
EXT. FLT
RPI
OK
COM OK
MCR
AUX IN 1
AUX IN 2
AUX IN 3
XMT
AUX IN 4
AUX IN 5
RCV
AUX OUT
LED
Indicates
GP
Gate Power is present
LP
Logic Power is present
OK
The drive regulator has passed its internal power-up diagnostic tests. After
power-up this LED will turn off if the internal "watchdog timer" fault occurs.
P.M. FLT
Shorted SCR, Field Current Feedback too low or too high.
EXT. FLT
Loss of AC Line Synchronization, AC Line Missing, Instantaneous Over-Current
(IOC), Over-speed, User program has initiated the illumination of the LED.
COMM OK
Drive Comm is active and synchronized.
FDBK OK
The SD3000 Plus is receiving feedback from the resolver and no resolver feedback
faults have been detected. If the LED is off, one of the following faults may have
occurred:
• Feedback Loss Fault - armature voltage has exceeded 40% of the rated value
and speed feedback has been less than 5% of motor base speed
• Broken Wire Fault - a resolver sine or cosine signal is missing
RPI
The Run Permissive Input (RPI) is energized.
AUX IN 1
Auxiliary Input 1 is energized. This input usually indicates the status of the
M-Contactor.
AUX IN 2
Auxiliary Input 2 is energized. This input often indicates the status of an inverting
fault circuit breaker.
AUX IN 3
Auxiliary Input 3 is energized. This input often indicates the status of the Power
Module's airflow switch.
AUX IN 4
Auxiliary Input 4 is energized. This input often indicates the status of the motor
thermal switch.
AUX IN 5
Auxiliary Input 5 is energized.
AUX OUT
Auxiliary Output is energized.
SD3000 PLUS DC Drive Regulator
Engineered by
FWD - GATES
GP
P.M. FLT
FDBK OK
LP
EXT. FLT
RPI
OK
COM OK
MCR
AUX IN 1
AUX IN 2
AUX IN 3
XMT
AUX IN 4
AUX IN 5
RCV
AUX OUT
REV - GATES
RESOLVER
FEEDBACK
METER
PORTS
DRIVE
I/O
ARM
FDBK
120VAC
EXT GATE P/S
L1
L2
FIELD
SD3000
PLUS
DRIVE CONTROL
7
FUSE TYPE
250VAC
3AG 7A