- ページ 2

スイッチ Avocent DSR 1024のPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Avocent DSR 1024 2 ページ。 Avocent dsr series dsr1024: install guide
Avocent DSR 1024 にも： パンフレット (2 ページ), リリースノート (3 ページ), ファームウェア・リリース・ノート (3 ページ), ファームウェア・リリース・ノート (3 ページ), ファームウェア・リリース・ノート (3 ページ), ファームウェア・リリース・ノート (3 ページ), リリースノート (3 ページ), リリースノート (1 ページ), リリースノート (2 ページ), リリースノート (2 ページ), 補足マニュアル (2 ページ)

ページを印刷する
Avocent DSR 1024 クイック・インストール・マニュアル
The following instructions will help you
to connect your DSR switch.
Should you require further assistance, please
consult your installer/user guide.
Telephone
network
DSView®
Server
Software
Connect the switch
to the network.
5
Connecting the network
Plug a CAT 5 cable from your Ethernet network into
the LAN port on the back of your DSR switch. Network
users will access the DSR switch through this port.
6
Connecting an external modem
(optional)
The DSR switch may also be accessed using an ITU
V.92, V.90 or V.34-compatible modem. Plug one end
of the included RJ-45 serial cable into the MODEM
port on the back of your DSR switch. Plug the other
end into the RJ-45 to DB-9 (male) adaptor, which
then plugs into the modem.
NOTE: Using a modem connection instead of a
LAN connection will limit the performance
capability of your DSR switch.
Avocent, the Avocent logo, The Power of Being There, DSView and DSR are registered trademarks of Avocent Corporation. All other marks are the property of their respective owners. ©2004 Avocent Corporation. All rights reserved.
Quick Installation Guide
DSR
To connect a DSR switch
(continued from reverse side)
Modem
Ethernet
5
7
Connecting the SPC power control
device (optional)
Plug one end of the cable supplied with the SPC power
control device into the SPC port on the DSR switch
and plug the other end into the SPC RJ-45 port. Plug
the power cord from the target server into an SPC
power outlet. Plug the SPC device into an appropriate
AC wall outlet.
®
1024 Switch
6
Plug in the
external modem.
DSR1024 Switch
The Power of Being There
SPC Power
Control Device
7
Connect the
target server and
DSR1024
switch to the
SPC device.
Server
8
Powering target and switch
Power up the target server and then power up the
DSR switch.
For additional information
For further instructions on DSR switch connection,
software setup and security configuration, please refer
to the installer/user guide included with the switch.
Check http://register.avocent.com for the latest DSR
software and firmware updates.
590-441-501A