- ページ 9

ボート Aqua glider ZS30のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aqua glider ZS30 11 ページ。 Motorized inflatable ride on

Accidental Flooding

Make sure the Battery Door Seal is clean, lubricated and

undamaged and the Battery Door is tightly connected.

However, should the seal not to be cleaned properly or

the battery door not fully closed and water enters the

battery compartment your Aqua Glider will not be

permanently damaged since it is designed for protection

against flooding.

If the Battery Compartment floods

1. Remove the unit from the water and set the master

switch to the locked position.

2. Unscrew the Battery Door using a coin or similar and

remove. (see fig.7)

3. Unplug and remove the rechargeable battery.

4. Thoroughly dry the battery compartment and

battery.

5. Check battery door seal and sealing surface, make

sure they are clean and lubricated.

You should use silicon grease to lubricate the seal -

this can be purchased from your local hardware

store.

6. Connect the battery to the battery compartment,

making sure to insert it the right way round.

fig.9)

7. Replace the battery door and turn the battery door

screw making sure it is tightened completely.

(see fig.11)

8. Connect the new Battery Compartment, insert it, and

screw in place.

If the propeller is blocked:

1. Remove Aqua Glider from water and dry completely.

2. Make sure the master switch is in the 'Off' position.

3. Unscrew rear grille. (see fig.13 )

4. Unscrew the propeller nut using an M6 socket.

(see fig.14)

5. Remove the washer, propeller and the drive pin.

(see fig.14)

Fig.13

nut

washer

drive pin

Fig.14