- ページ 7

ダイビング機器 Aqua Jet SA 3995のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aqua Jet SA 3995 10 ページ。 Hammer head

CAUTION

• Only charge the battery in a well ventilated place and ensure that there is enough room to dissipate

the gas arising from charging. The venting plug must be opened when charging the battery and always

allow at least one minute for the gas to dissipate after the venting plug is opened prior to removing or

attaching the custom-made charging plug

• Always plug the custom-made charging plug into the battery compartment first then plug into the main

power supply. Upon completion of charging, unplug the main power first then the charging plug.

• Always ensure the charger and the plug are in dry conditions and keep them away from water.

• Always charge the battery until the LED indicator on the charger turns to green. If in doubt about the

battery status, always recharge the battery again to ensure the battery is fully charged prior to use.

Charging the Battery

• The Aqua Jet is specially designed to enable the user to replace a used up battery on the Board easily.

Users should replace and charge the battery according to the following

procedures so as to provide the best care for the product:

1. Ensure that the Aqua Jet is out of the water and placed in a dry area

2. Turn off the Main Switch

3. Turn the two latches as indicated in diagram 10

4. Hold the handle and remove the battery from the Motor Driver

diagram 10