スイッチ Avocent SwitchViewのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Avocent SwitchView 2 ページ。 Kvm switching solutions from your desktop
Avocent SwitchView にも： インストーラー/ユーザーマニュアル (17 ページ), ユーザーマニュアル (17 ページ), 仕様 (4 ページ), クイック・インストール・マニュアル (8 ページ)
ページを印刷する
The following instructions will help you
connect your SwitchView unit.
Should you require further assistance, please
contact Avocent Technical Support.
NOTE: All drivers necessary for the SwitchView
are built into the unit. If you are installing the unit
with a Windows operating system and are
prompted for drivers, press NEXT until the
configuration is complete.
1
Powering the SwitchView unit
Power down all computers that will be attached to your
SwitchView unit. Plug the supplied power cord into the
power socket on the rear of the SwitchView unit. Plug
the other end into an appropriate AC power source.
2
Connecting the peripheral devices
Plug your VGA monitor into the port labeled CONSOLE
on the back of the SwitchView. If you plan to use a
PS/2 keyboard or mouse locally, plug them into the
labeled ports on the front of the unit.
NOTE: PS/2 local peripherals will work with USB
or PS/2 computers.
3
Connecting the first computer
To connect a computer using the PS/2 ports:
Locate an industry standard KVM to KVM cable.
Attach one end to the corresponding connectors on
the first computer to be attached to the SwitchView.
Quick Installation Guide
SwitchView USB
To connect a SwitchView USB
5
Attach USB
devices to the
front ports of the
SwitchView unit.
2
Plug in the monitor,
Power down your
followed by
computers and attach
the keyboard
the appropriate
and mouse.
power cord.
Route the cable to the SwitchView and attach the
remaining connectors to an available port set. The
port sets are labeled PC1-PC4 to correspond with
the channels on the unit.
To connect a computer using the USB port: Attach
an industry standard USB cable between an available
USB port on the rear of the SwitchView and the
computer you are attaching.
4
Connecting the remaining computers
Repeat step 3 to connect additional computers.
1
2
3
4
PC4
CONSOLE
3
PC3
4
C
UPGRADE
DC 12V, 1A
1
3
Connect the first
computer to the
SwitchView unit.
5
Connecting USB devices
Plug any USB devices or peripherals into the SwitchView
using the USB ports on the front of the unit.
6
Powering the SwitchView unit and
attached computers
Power the SwitchView. Next to each port is a blue
LED. A blinking LED indicates that the attached
computer is not powered.
Power the first attached computer. Wait until it
has completely booted before switching to the
next computer and repeating the process.
The Power of Being There
6
Power up the
SwitchView unit
and all attached
PC2
1
PC1
computers.
2
4
Plug in the remaining
computers to the
or
SwitchView unit.
590-345-001A