- ページ 10

パーソナルケア製品 DEZEGA EmSCAPEのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DEZEGA EmSCAPE 20 ページ。 Emergency escape hood
DEZEGA EmSCAPE にも：ユーザーマニュアル (16 ページ)

DEZEGA EmSCAPE

DEZEGA

The hood 1 is made of reflective material and consists of a visor 3,

a half-mask 2, headband straps 4. With headband straps 4 that

require no adjustment, half-mask 2 fits tightly a human face. The

obturator at the bottom of the hood prevents the suction of toxic

substances under the hood.

Gas mixture in the breathing system of the escape hood circulates

within the pendulum scheme of flow.

During exhale breathing mixture goes through the half-mask 2, then

through the breathing tube 5 it gets into the regenerative cartridge 8.

The regenerative cartridge absorbs carbon dioxide and moisture from

the gas mixture and releases the volume of oxygen proportional to the

volume of absorbed substances. Breathing mixture from regenerative

cartridge 8 goes to the breathing bag 12.

When the user inhales, oxygen-enriched gas mixture from the breathing

bag 9 re-enters the cartridge 8 where it is further purified from carbon

dioxide and returns to the half-mask 2 to the respiratory organs through

the breathing tube 5.

Surplus breathing mixture during exhale leaves the breathing bag 9

through the relief valve 10.

To fill the breathing bag 12 and provide oxygen in the first minutes

after donning the escape hood, activate the starter by pressing the

quick release buckle for starter launch 9.

After putting on the hood, tighten the adjusting straps 6.

When the oxygen-containing product in the cartridge absorbs carbon

dioxide and moisture, heat is released. The surface of the cartridge

and the breathing mixture therefore heat as well. This indicates,

that the escape hood is operating correctly, and it should not cause

any anxiety. To prevent discomfort after donning that is caused by

excess heat formation, the heat shield 13 is used.